vibration dampener foot for centauri carbon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A vibration dampener foot for the centauri carbon (you will need 4). To be used with either rubber nonslip or TPU pads
- Ocena
- 4 / 5
- Polubienia
- 7
- Pobrania
- 38
- Wydruki
- 1
- Wyświetlenia
- 456
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A set of vibration dampener feet for the Centauri Carbon. I adjusted the feet to fit the CC. The original model had a curved bottom which resulted in slipping across the desk. I flattened the bottom and added screw holes to allow non-slip rubber feet to be added. 4 screw holes for each foot (i.e. 16 screws and 16 non-slip rubber feet). You could probably also print the non-slip feet in TPU (or simply print a rectangular boot to fit around the base of the feet) to get the same effect.
I orient the feet diagonally to the printer with opposite corners being parallel and adjacent corners being perpendicular, that way vibrations can be distributed evenly.
I printed it in PETG which works well. Also, printing it on its side allows it to be printed without supports.