vibration dampener foot for centauri carbon
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A vibration dampener foot for the centauri carbon (you will need 4). To be used with either rubber nonslip or TPU pads
- Rating
- 4 / 5
- Likes
- 7
- Downloads
- 38
- Makes
- 1
- Views
- 456
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A set of vibration dampener feet for the Centauri Carbon. I adjusted the feet to fit the CC. The original model had a curved bottom which resulted in slipping across the desk. I flattened the bottom and added screw holes to allow non-slip rubber feet to be added. 4 screw holes for each foot (i.e. 16 screws and 16 non-slip rubber feet). You could probably also print the non-slip feet in TPU (or simply print a rectangular boot to fit around the base of the feet) to get the same effect.
I orient the feet diagonally to the printer with opposite corners being parallel and adjacent corners being perpendicular, that way vibrations can be distributed evenly.
I printed it in PETG which works well. Also, printing it on its side allows it to be printed without supports.