Radiomaster Pocket Phone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
better Phone or screen holder for Radiomaster Pocket
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 140
- Wydruki
- 2
- Wyświetlenia
- 836
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a 3D-printable phone and screen mount for the Radiomaster Pocket controller. With a wide clamping range of 64mm to 84mm, this mount can hold almost all modern smartphones. The design is inspired by an expensive commercial mount found on AliExpress, offering a much more affordable and accessible alternative.
For smartphones with slippery sides or those used without a case, you can optionally glue self-adhesive silicone bumpers into the holder's recesses for a more secure grip.
Required Hardware:
- 1x M4x25 screw (or longer)
- 1x M4 nut
- 1x Rubber band (A 4x25mm band, like model RA014, fits perfectly)
Z-Seam: For the cleanest finish, try to position the Z-seam as shown in the images.
⚠ IMPORTANT: To fit this mount correctly, you must first remove the original plastic snap-fit tabs
Phone Compatibility:
This mount is designed to hold phones or screens with the following dimensions:
- Clamping Range (Width): 64mm to 84mm
- Maximum Thickness: 10mm