Radiomaster Pocket Phone Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
better Phone or screen holder for Radiomaster Pocket
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 140
- Makes
- 2
- Views
- 849
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
This is a 3D-printable phone and screen mount for the Radiomaster Pocket controller. With a wide clamping range of 64mm to 84mm, this mount can hold almost all modern smartphones. The design is inspired by an expensive commercial mount found on AliExpress, offering a much more affordable and accessible alternative.
For smartphones with slippery sides or those used without a case, you can optionally glue self-adhesive silicone bumpers into the holder's recesses for a more secure grip.
Required Hardware:
- 1x M4x25 screw (or longer)
- 1x M4 nut
- 1x Rubber band (A 4x25mm band, like model RA014, fits perfectly)
Z-Seam: For the cleanest finish, try to position the Z-seam as shown in the images.
⚠ IMPORTANT: To fit this mount correctly, you must first remove the original plastic snap-fit tabs
Phone Compatibility:
This mount is designed to hold phones or screens with the following dimensions:
- Clamping Range (Width): 64mm to 84mm
- Maximum Thickness: 10mm