1 / 2
FanCover for Anycubic Vyper Dual 5015 V2 Rev2 when using Revo Six Hotend — zdjęcie 1
1 / 2

FanCover for Anycubic Vyper Dual 5015 V2 Rev2 when using Revo Six Hotend

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mesh fan cover for Anycubic Vyper Dual 5015 V2 Rev2 in case you switch from the default Volcano V5 to a Revo 6 Hotend

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
92
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I printed the Butterfly printhead fro my AC Vyper which was created by "DerLatzer" on Thingiverse https://www.thingiverse.com/thing:4974423 which worked pretty good for me, as long as I was using the factory VolcanoV5 Hotend.
After switching to the E3D Revo Six hotend which requires an adapter to be mounted, I found out, that all available adapters are a little longer than the factory hotend and the Coldend is not perfectly cooled because the fan sits a little too high.
So I created a FanCover which lowers the fan a little which now cooles the entire Coldend

Additionally I used 2 M3x25 screws an nuts to mount the fan to the Fancover. I designed it with 4 holes, but two are enough to.

I designed it for my 40x40x20 fan, but I will also upload a version for the 40x40x10 stock fan. There you can use M3x16 screws.

Tagi