1 / 2
Logitech C525 Light mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I needed a light for lighting my 3d prints. I modified Oleksii Zelivianskyi his model adding a mount for an LED light. The LED light itself is controlled through a Raspberry Pi running OctoPi with the OctoLight plugin (https://github.com/thomst08/OctoLight).
Print with lens part down on the print bed. No glue required, the led should just press fit into the square recess the wires you can just solder on and feed through the provided slot.
Bill of materials:
- 1x 5mm Piranha Cool/Clear White LED (https://www.amazon.com/5mm-Piranha-Cool-Clear-White/dp/B017TRDWN8)
- 26awg Wire Flexible Silicone Wire (https://www.amazon.com/dp/B07G2LRX68)
- 10 Ohm resistor (https://www.amazon.com/BOJACK-Values-Resistor-Resistors-Assortment/dp/B08FD1XVL6)
- Dupont connecter set (when not soldering it directly to a micro controller) (https://www.amazon.com/Glarks-1191Pcs-Housing-Connector-Compatible/dp/B07TB8QXMC)