1 / 4
Ultimulti MMU3 Legs for CoreONE Enclosed — zdjęcie 1
1 / 4

Ultimulti MMU3 Legs for CoreONE Enclosed

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Update - Don't use this, the tube doesn't go nicely into the enclosure top. I'm using the Table Top mount by @Clamikra

Ocena
0 / 5
Polubienia
4
Pobrania
15
Wydruki
1
Wyświetlenia
393
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Update - Don't use this, the tube doesn't go nicely into the enclosure top.  I'll need to lower it, which will require the re-working of the electronics.  I'm not very happy with the access once completed.  See the picture.

I switched back to using the Magnetic Table Top Mount by @clamikra

https://www.printables.com/model/897207-magnetic-table-stand-for-ultimulti-mmu-also-attach

I couldn't find legs for the UltiMulti MMU3 with the Original Prusa Enclosed MMU3 upgrade, so I smashed the excellent revised UltiMulti legs for PDU from @bryn51 with the legs from the Prusa Enclosed MMU3 upgrade and reinforced them.  

I also modified the USB port to allow my microUSB (gross) to USB-C adapter to fit nicely.  

Since I'm a terrible 3D Modeler, I couldn't nicely clean up some of the faces in Blender, and I didn't care about fixing the bezels around the outside.  I also struggled to remove the second cut on the Left leg after mirroring the part and said forget about it; its five hours past bedtime.  If it fits, it ships!  There's no more permanent fix than a temporary solution.  I used the repair model in PrusaSlicer to clean it up before printing (again, I don't know what I'm doing). If a better modeler (literally anybody) wants to clean these up or improve them, please do!

I printed individually Draft mode, 23-27 minutes with Inland PLA.  Once it was good enough, I sent it.

Tagi