Ultimulti MMU3 Legs for CoreONE Enclosed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Update - Don't use this, the tube doesn't go nicely into the enclosure top. I'm using the Table Top mount by @Clamikra
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 15
- Makes
- 1
- Views
- 393
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Update - Don't use this, the tube doesn't go nicely into the enclosure top. I'll need to lower it, which will require the re-working of the electronics. I'm not very happy with the access once completed. See the picture.
I switched back to using the Magnetic Table Top Mount by @clamikra
https://www.printables.com/model/897207-magnetic-table-stand-for-ultimulti-mmu-also-attach
I couldn't find legs for the UltiMulti MMU3 with the Original Prusa Enclosed MMU3 upgrade, so I smashed the excellent revised UltiMulti legs for PDU from @bryn51 with the legs from the Prusa Enclosed MMU3 upgrade and reinforced them.
I also modified the USB port to allow my microUSB (gross) to USB-C adapter to fit nicely.
Since I'm a terrible 3D Modeler, I couldn't nicely clean up some of the faces in Blender, and I didn't care about fixing the bezels around the outside. I also struggled to remove the second cut on the Left leg after mirroring the part and said forget about it; its five hours past bedtime. If it fits, it ships! There's no more permanent fix than a temporary solution. I used the repair model in PrusaSlicer to clean it up before printing (again, I don't know what I'm doing). If a better modeler (literally anybody) wants to clean these up or improve them, please do!
I printed individually Draft mode, 23-27 minutes with Inland PLA. Once it was good enough, I sent it.