Advwin 6L with camera automatic feeder and Surefeed combination
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed this design by Ana (and originally https://www.thingiverse.com/thing:6206548/files) to fit my advwin base
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 322
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Unfortunately my advwin base was different dimensions to the other options out there so have made my own with some amateur 3d modelling skills. I also added alternate connector slots on the base to allow the feeder to be placed to one side if using the 2 bowls for the surefeed feeder. (and also included a modded lid to allow the one side feeding). Also the angle of my slide must be slightly different so i had to make the hole bigger for the slide to work, and a new slide. Stuck the slide in with some VHB tape, and some gorilla glue to hold the lid of the slide on well
EDIT: Added ramp base model, this adds a 10degree tilt to the whole system, helps avoid build up of kibble right under the ramp. Also has two small holes for the “clips” that can just slot in, I had to print the clips at 95% for a good fit.
Not sure i can add much to the print tips, I don't really know how to change printer options much so basically just printed these in default. Follow Anas guide.