Kief Press
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I upgraded the strength and tightness of the design to use as a keif to Hash press. Now you can press hard enough that you will need a chisel to use the hash (don't do that, use a lighter touch).
I strongly recommend adding PTFE tape to the flat (puck contact) side of the internal plates. I happened to use the 1 in. version this one, but many are available: https://www.amazon.com/dp/B07XFK235 Parchment paper can be used too, but it is not as effective.
Run the plungers through the system a few times. Then wipe the internal parts clean before you use it to clear off any loose plastic. With the tighter internal parts, there will be a little plastic residual to clean out that you don't want in the puck.
All the strengthening was so I could use PLA filament. Even with all the extra strength, you can still break PLA. Use to PLA+ at a minimum. Ideally use something stronger that is food grade (not all PLA is food grade)