1 / 4
NanoPi NEO3 under desk / wall mounting enclosure
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for NanoPi NEO3 for mounting under a desk or on a wall.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
This enclosure is designed to mount the NanoPi NEO3 under a desk or on a wall.
Difficulty Level: Advanced
- A heated chamber is highly recommended.
- Brass hot melt inserts require careful installation.
Preferred Printing Settings
- Material: ASA (tested), ABS
- Infill: 30% rectilinear
- Perimeters: 3 (1.2mm)
- Layer height: 0.1mm
- Solid layers: 12 (1.2mm)
- Supports: not required
- Nozzle diameter: 0.4mm
Additional Components Required
- Four M3 x 5mm Brass hot melt inserts (4.2mm OD)
- Four M3 x 12mm hex socket or decorative head screws
- Four M3 x 12mm screws with a small, flat-bottomed head
- Four M3 nuts
Additional Tools
- Heat-Set Insert Installation Tool
Warnings!
- Do not use countersunk head screws! Use only screws with a flat head on the bottom.
- There is very little free space on the PCB around the mounting holes. For this reason:
- Be sure to carefully check that the screw heads are not too large.
- Confirm that there is sufficient space around all mounting elements.
- Assemble the PCB to the mounting frame very carefully to avoid damaging the components.
Notes
- Brass hot melt inserts must not protrude above the surface.
If precise placement is a problem, it's better for them to be slightly recessed than to stick out. - Due to limited free space, the mounting holes in the PCB mounting frame are designed with very little clearance - if they turn out to be too tight in the printout, they can be slightly filed out.
