1 / 4
NanoPi NEO3 under desk / wall mounting enclosure — image 1
1 / 4

NanoPi NEO3 under desk / wall mounting enclosure

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Enclosure for NanoPi NEO3 for mounting under a desk or on a wall.

Rating
0 / 5
Likes
0
Downloads
8
Makes
0
Views
104
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Public Domain

This enclosure is designed to mount the NanoPi NEO3 under a desk or on a wall.

Difficulty Level: Advanced

  • A heated chamber is highly recommended.
  • Brass hot melt inserts require careful installation.

Preferred Printing Settings

  • Material: ASA (tested), ABS
  • Infill: 30% rectilinear
  • Perimeters: 3 (1.2mm)
  • Layer height: 0.1mm
  • Solid layers: 12 (1.2mm)
  • Supports: not required
  • Nozzle diameter: 0.4mm

Additional Components Required

  • Four M3 x 5mm Brass hot melt inserts (4.2mm OD)
  • Four M3 x 12mm hex socket or decorative head screws
  • Four M3 x 12mm screws with a small, flat-bottomed head
  • Four M3 nuts

Additional Tools

  • Heat-Set Insert Installation Tool

Warnings!

  • Do not use countersunk head screws! Use only screws with a flat head on the bottom.
  • There is very little free space on the PCB around the mounting holes. For this reason:
    • Be sure to carefully check that the screw heads are not too large.
    • Confirm that there is sufficient space around all mounting elements.
    • Assemble the PCB to the mounting frame very carefully to avoid damaging the components.

Notes

  • Brass hot melt inserts must not protrude above the surface. 
    If precise placement is a problem, it's better for them to be slightly recessed than to stick out.
  • Due to limited free space, the mounting holes in the PCB mounting frame are designed with very little clearance - if they turn out to be too tight in the printout, they can be slightly filed out.