3D Printed Rods and Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Alternative 3D printed rods and centre support
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 46
- Wydruki
- 1
- Wyświetlenia
- 262
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So I ran out of steel tube/rod for this design and only need a small piece.
I decided to print the rods in PETG and add a support for the centre of the rod. They flex a bit but function adequately to hold in the filament.
I'D ONLY RECOMMEND USING PETG OR STRONGER ON THE LOWER SUPPORT, PLA IS NOT SUITABLE.
A stronger filament (ABS?) is needed if you want to do the upper filament holder. I haven't tried this yet.
This will require a high infill, I tried 60% but possibly 100% might have been better for the rod. The support is fine in PLA. I used a 0.2mm line thickness.