[WIP] Meshlicious GPU Back Brace
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A support designed for the rear GPU finger in a Meshlicious case.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 1317
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
A support designed for the rear GPU finger in a Meshlicious case. Gives more surface area to support the bracket from bending. This is meant to be used when the GPU is in the higher position and in 4-slot mode.
Currently this design is slightly flawed. I didn't account for a raised screw hole on the bottom of the case that this bracket is intended to sit on. I designed this as a one-off for me, so I just melted the groove into the leg with a soldering iron.
Publishing this by request. This design is a WIP, but unlikely I'll properly fix that issue. Go into this knowing that in advance.