[WIP] Meshlicious GPU Back Brace
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A support designed for the rear GPU finger in a Meshlicious case.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 62
- Makes
- 0
- Views
- 1,317
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A support designed for the rear GPU finger in a Meshlicious case. Gives more surface area to support the bracket from bending. This is meant to be used when the GPU is in the higher position and in 4-slot mode.
Currently this design is slightly flawed. I didn't account for a raised screw hole on the bottom of the case that this bracket is intended to sit on. I designed this as a one-off for me, so I just melted the groove into the leg with a soldering iron.
Publishing this by request. This design is a WIP, but unlikely I'll properly fix that issue. Go into this knowing that in advance.