1 / 4
Printable cat feeder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is yet another cat feeder design.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 92
- Wydruki
- 1
- Wyświetlenia
- 3271
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (0)Kolekcje (47)Powiązane
This is yet another cat feeder design. It has the nice property that it is fully printable (aside from the container which comes from amazon) and uses an RC servo for dispensing. Basically works fine if paired with a Rasberry pi or somesuch to turn the servo on briefly.
You'll want to buy this cheap cereal dispenser and print these three parts.
Assembly:
- Use the screws that come with the servo to attach it to the mounting bracket (they are self tapping)
- Put the printed pin in instead of the knob that comes with the cereal dispenser (there is no need to to use screws to attach the arm to the servo)
- Attach the bracket to the collar with two M3 screws - about 20mm long or so.
Note: photo shows a slightly earlier design, the files uploaded fit better than that early revision... ;-)
Print instructions
Category: Pets Print Settings
Filament: any PETG would be best but PLA is okay also