LuerLock Keychain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Luerlock saline flush cap keychain. can be attached to your flight vest via ziptie or other cable
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 432
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
In an attempt to make them a little more airtight I dropped the layer height to .12mm instead of .20 and used supports. Printed for flight medicine.
My Orcaslicer settings
- .12mm layer height .4mm nozzle
-Wall loops 3
-Support - Tree, threshold angle 15
-Seam position- aligned
-Flashforge PETG plus
Remix of wavexx M/F luer lock
Their instructions/ information are as follows:
Double-ended Male/Female Luer Lock Cap. In the image the red parts are printed in FDM while the blue ones are the original injection-molded part.
Fully 3D-printable in FDM in both orientations, no supports required.
Optimized for a 0.4 nozzle, 0.15 layers or less.
WARNING: the seal likely won't be air-tight due to imperfections in the printing process. Liquid can also penetrate between micro-fissures between the layers. You must consider if these limitations can affect your experiment.
Cooling and material is extremely important when printing this part accurately: PETG or PP recommended. Always print multiple copies to ensure the material doesn't overheat while printing.
Using a SLS/SLA process should result in an air-tight part.
A big shoutout to this page which provided a good basis for the measurements.