LuerLock Keychain
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Luerlock saline flush cap keychain. can be attached to your flight vest via ziptie or other cable
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 56
- Makes
- 0
- Views
- 432
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
In an attempt to make them a little more airtight I dropped the layer height to .12mm instead of .20 and used supports. Printed for flight medicine.
My Orcaslicer settings
- .12mm layer height .4mm nozzle
-Wall loops 3
-Support - Tree, threshold angle 15
-Seam position- aligned
-Flashforge PETG plus
Remix of wavexx M/F luer lock
Their instructions/ information are as follows:
Double-ended Male/Female Luer Lock Cap. In the image the red parts are printed in FDM while the blue ones are the original injection-molded part.
Fully 3D-printable in FDM in both orientations, no supports required.
Optimized for a 0.4 nozzle, 0.15 layers or less.
WARNING: the seal likely won't be air-tight due to imperfections in the printing process. Liquid can also penetrate between micro-fissures between the layers. You must consider if these limitations can affect your experiment.
Cooling and material is extremely important when printing this part accurately: PETG or PP recommended. Always print multiple copies to ensure the material doesn't overheat while printing.
Using a SLS/SLA process should result in an air-tight part.
A big shoutout to this page which provided a good basis for the measurements.