1 / 1
TGauge Train Track Piers - Gradual Incline (1st draft) — zdjęcie 1

TGauge Train Track Piers - Gradual Incline (1st draft)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A set of piers that raise your TGauge track 2mm at a time for a long, slow incline. WIP!

Ocena
0 / 5
Polubienia
7
Pobrania
38
Wydruki
0
Wyświetlenia
212
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is my first draft of a set of twelve piers for a very gradual incline for TGauge (1:450 scale) track. The pier heights increase by 2mm each. The smallest is 2mm and the tallest is 24mm (measured at the point where the track sits on the pier's top surface.

I'm not super happy with how the shorter piers came out now that I've printed them. They're looking pretty ugly and much too wide, so I'm going to make adjustments to that and maybe make the top clips a tiny bit looser for easier use. I also plan to make a set with a steeper incline, but that's for later.

I recommend printing with a layer thickness of 0.1mm. Supports aren't necessary with my MK4S; your printer's capabilities may vary.

Download the zip file to get all 12 at once.

Tagi