Nautilus Speaker - Tang Band W3-1878
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Nautilus speaker design for the Tang Band W3-1878 full-range speaker driver.
- Ocena
- 0 / 5
- Polubienia
- 42
- Pobrania
- 271
- Wydruki
- 0
- Wyświetlenia
- 1251
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The enclosure has a volume of approx. 3.15 liters. The port was tuned to 89 Hz with a slight dip in response above that according to WinISD. The dip can be corrected with an equalizer at 175 Hz +1.5 dB (Q=1.0). With these settings, the cone excursion is below 3.7 mm (max 4.2 mm) and the air velocity is below 22 m/s. The full-range speakers are supported by a woofer from Dayton Audio - TCP115-4.
The model is split in half to fit on my Bambu Lab P1S. However, the model as one single piece was attached as well.
Print settings used:
- 0.6 mm nozzle
- 0.18 mm layer height
- 3 walls
- 40 % gyroid infill
I used M12 speaker spikes as stand-off, which were melted into place after printing.