Nautilus Speaker - Tang Band W3-1878
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Nautilus speaker design for the Tang Band W3-1878 full-range speaker driver.
- Rating
- 0 / 5
- Likes
- 42
- Downloads
- 267
- Makes
- 0
- Views
- 1,232
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The enclosure has a volume of approx. 3.15 liters. The port was tuned to 89 Hz with a slight dip in response above that according to WinISD. The dip can be corrected with an equalizer at 175 Hz +1.5 dB (Q=1.0). With these settings, the cone excursion is below 3.7 mm (max 4.2 mm) and the air velocity is below 22 m/s. The full-range speakers are supported by a woofer from Dayton Audio - TCP115-4.
The model is split in half to fit on my Bambu Lab P1S. However, the model as one single piece was attached as well.
Print settings used:
- 0.6 mm nozzle
- 0.18 mm layer height
- 3 walls
- 40 % gyroid infill
I used M12 speaker spikes as stand-off, which were melted into place after printing.