Rev 2 EX BCAR Suppressor Shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for the Xshot MPP, but usable with any blaster. Adds a cosmetic shroud around the whole BCAR.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 589
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Can be used on any blaster that takes the EX BCAR rev 2 and has the exposed barrel space behind the bcar to accommodate the suppressor. Replaces the “DecoRing” part of the BCAR.
Four versions are available:
- Regular for Classic BCAR (123mm*)
- Longer for Classic BCAR (153mm*)
- Regular for ClassicLong BCAR (160mm*)
- Longer for ClassicLong BCAR (Pictured on Piston Pump, 190mm*)
**Lengths are measured with the endcap screwed on
The threaded endcap works for either version
Printing Instructions:
End cap does not need supports at all.
Suppressor needs support but only on the overhang near the middle of the suppressor, not in the threads. Feel free to add a support blocker on the threads, or just print it with the threads facing up with a brim.
You can add a pause to change the colour to orange for the end if you want, or just paint it in Bambu if you have an AMS. I added mine around 20mm from the top.
Assembly Instructions:
Slide the suppressor threaded end cap down the barrel, threaded side facing towards where the BCAR will go.
Insert the thread and collet as normal, tighten collet so that it stays on the barrel.
Slide the suppressor on top of the barrel, making sure that it locks in place in the DecoRing slots.
Thread the BCAR end onto the barrel, locking the suppressor in place. You don't need to overtighten this, it will just make it hard to get it out in the future.
Thread the end cap onto the suppressor and tighten.
