Prusa CORE One Camera enclosure for Wyze Cam v3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for Wyze Cam v3 to be mounted inside Prusa CORE One in the similar way as Buddy3D Camera.
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 50
- Wydruki
- 2
- Wyświetlenia
- 587
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Build your own Buddy3D-like Camera from Wyze Cam V3 for your CORE One.
With this enclosure you can build Buddy3D-like camera from Wyze Cam V3. This is somewhat destructive to the Wyze Cam V3, but if you're careful and record the process it can be reversed.
This project was inspired by Prusa CORE One Camera: Internal Wyze V4 and Learn3DP Cam which is designed for Wyze CamV4. I wanted to use specifically Wyze Cam V3 as it can be flashed easily with Thingino and stay completely local.
Printing
- Material: ASA/ABS or PETG due to high temperature inside the printer + heat coming from the camera itself.
- Layer: 0.2mm, but others are possible, although not tested.
- No supports.
- Brim recommended for the front part.
- Orientation: Front on its face, back on the flat, triangle side (see the picture).
Camera preparation
Camera needs to be disassembled and stripped to the main board only. This includes microphone, IR LEDs and SD card reader. I found this video helpful. The only really destructive part is to break original enclosure to set free the original micro-USB cable. It can be also cut and soldered, but I didn't plan to re-use original enclosure anyway.
Thingino installation is optional and it's also reversible. Please find instructions in this GitHub repository. It is recommended to install Thingino before camera disassembly.
Assembly
3 15x2mm magnets are needed to attach camera to the Prusa CORE one enclosure. In my case they fit snug enough that no glue was needed. If they are loose please use some CA glue (Super glue).
There is only one way to insert to the camera to the front part. Please route cable inside as in the picture below. Back can be attached also only in one way to fit antenna, cable connector and cable itself.
After that camera should be installed in the front left corner (same as Buddy3D) with cable routed in the same way.