1 / 2
European 4-1 Chainmail (400 rings)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
print-in-place chainmail
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 165
- Wydruki
- 0
- Wyświetlenia
- 764
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (25)Powiązane
print-in-place chainmail for props / cosplays
0.2mm layer height is recommended. Supports are hand-modeled in the STL, so do not enable supports upon slicing. It prints fine with Bambu's default 0.2mm configuration.
When printed, ply off the bottom sheet first, then remove small pillars left attached to the chainmail. Removing support pillars requires quite some time as they are so many, but most indivisual pillars should be able to be snapped off.