1 / 5
MDD Direct Drive Clone Hero Me Ender 3 Gantry Plate — zdjęcie 1
1 / 5

MDD Direct Drive Clone Hero Me Ender 3 Gantry Plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gantry plate for Hero Me to fit the cheaper MDD plates (not from PrinterMods) available in countries outside of the US

Ocena
0 / 5
Polubienia
6
Pobrania
42
Wydruki
0
Wyświetlenia
1200
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Backstory

I purchased one of the cheaper knockoff MDD v1.2 (Modular Direct Drive) plates and was unhappy when I found that the holes for the gantry plate were not aligning. Therefore I remixed the original gantry plate adapter (PM_CR-Ender_OEM-MS_Gantry_Adapter_5A) from the HMG6 to fit the two threaded holes in the MDD plate. 

The relative positions of nozzle and ABL mount as well as their heights are unchanged. I slightly modified the spacer for the hotend to make room for better air flow from the hotend cooler. 

 

Models

I uploaded two versions, one with chamfers and one without. I always like to have rounded corners, since the printers are unable to print right angles anyway. However, if you don't like it use the _NoChamfer version.

 

Printing:

  • No supports required
  • Infill: 35-50% 
  • Walls: 4

 

If you have questions or like this print, consider leaving a like, comment or a make. Thank you!

Tagi