1 / 4
Food / Freezer Bag Clip - 9cm (90mm) and 14cm (140mm)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quick, no supports needed, reliable freezer bag clips. I have dozens of them and <3 them
- Ocena
- 4,5 / 5
- Polubienia
- 85
- Pobrania
- 815
- Wydruki
- 7
- Wyświetlenia
- 1849
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 7) (Komentarze: 11)Remiksy (1)Kolekcje (107)Powiązane
This is a super handy clip for the pantry, freezer and just other bags. We use them for chip bags, and freezer stuff. I print them using PLA+, and we have clips that we are still using that have lasted 6/7/8 years in the freezer. And are just super good at sealing bags.
Notes/History:
This is a remix from an existing one I have used many times. I wanted to make a couple of quick modifications as I have a printer that is very "tight" on the first layer. The key changes are below:
- The "hinge" base is a bit looser on the first layer and then bends in, this makes it print better if the printers tolerance is lower
- The pull-away part on the hinge after you print could touch the surface, so I moved it away a little bit
- I made the "tip" a bit angled, so it "bites" more and holds together longer
- I added more of a V shape on the back of the arms, as triangles give better structure support long term (less prone to breaking)
- I "thinned" some areas, reducing the material by about 20%
- Small adjustments around the hinge to make it less likely be stuck together after printing
Note:
- After printing: You need to remove the little half-circle on the hinge, it's used as a pseudo support. I use a tiny screwdriver to pop it off.
