1 / 4
Food / Freezer Bag Clip - 9cm (90mm) and 14cm (140mm)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quick, no supports needed, reliable freezer bag clips. I have dozens of them and <3 them
- Rating
- 4.5 / 5
- Likes
- 85
- Downloads
- 815
- Makes
- 7
- Views
- 1,849
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a super handy clip for the pantry, freezer and just other bags. We use them for chip bags, and freezer stuff. I print them using PLA+, and we have clips that we are still using that have lasted 6/7/8 years in the freezer. And are just super good at sealing bags.
Notes/History:
This is a remix from an existing one I have used many times. I wanted to make a couple of quick modifications as I have a printer that is very "tight" on the first layer. The key changes are below:
- The "hinge" base is a bit looser on the first layer and then bends in, this makes it print better if the printers tolerance is lower
- The pull-away part on the hinge after you print could touch the surface, so I moved it away a little bit
- I made the "tip" a bit angled, so it "bites" more and holds together longer
- I added more of a V shape on the back of the arms, as triangles give better structure support long term (less prone to breaking)
- I "thinned" some areas, reducing the material by about 20%
- Small adjustments around the hinge to make it less likely be stuck together after printing
Note:
- After printing: You need to remove the little half-circle on the hinge, it's used as a pseudo support. I use a tiny screwdriver to pop it off.
