Duck Clamp - PCB Soldering Helper / helping hand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This easy-to-print, universal clamp can be used to hold PCBs and cables. It can be attached to any suitable metal surfac
- Ocena
- 5 / 5
- Polubienia
- 136
- Pobrania
- 168
- Wydruki
- 2
- Wyświetlenia
- 1868
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
These are easy and quick to print. They can be attached them to any suitable metal surface.
Old 3D printer flex plates work great. I used a 120x120mm Plate from a Voron 0. The case is designed for this size.
There are two versions of the feet. One has the magnet flush to the bottom and the other has a 1mm gap at the bottom.
Print both and select the appropriate one depending on your surface.
Required Hardware for one clamp
- M3x20 (DIN 912)
- M4x30 (DIN 912)
- Neodymium Magnets Extra Strong 12 x 3 mm Aperture 4 mm https://amzn.to/4oMRswd
- Steel Hollow Ball M4 x 10 mm Thread https://amzn.to/47cDsoZ
- Spring 13-17mm uncompressed length and 5mm ID should be fine. Get a cheap set and try what feels best.
Assembly:
The tolerances are tight and you should use a drill bit to smooth the holes to make them slide better.
Tap the M3 and M4 holes.
Gridfinity compatible Case:
Required Hardware:
- 8x M5x10 (ISO 7380-1)
- 1x 120x120mm Metal Plate (Voron 0 Flex plate)
Assembly:
The housing is designed so that the screws can be screwed directly into the plastic. The holding force can be adjusted via the screw-in depth.
For example, four can be set so that they adhere to the metal plate when opened and the other four so that they remain in the housing.