Avocado seed floater - mason jar compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An avocado seed floater that fits in jars with an internal dimension smaller than 68mm (.. approx 2.67ish inches)
- Ocena
- 4 / 5
- Polubienia
- 9
- Pobrania
- 30
- Wydruki
- 1
- Wyświetlenia
- 190
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hey!
I was using this model made by Mikolas Zuza, but it sadly did not fit any of my jars - it was just a little too big. Instead of scaling it down I used it as a designing excercise to make essentially the same model, except that it is smaller, and is designed for 0.6mm nozzles.
How to make the model “watertight”
- force the slicer to use bigger line width (eg. stock is 0.62 → use 0.67)
- use higher flow ratio (eg. stock is 0.98-1.0 → use 1.1)
- bump the temp up, for PLA I used 240°, instead of 205-215° which I normally use
- slow the print down, I used 50-75mm/s
- experiment with filaments, petg should be easier than pla for this, but I used PLA and made it work