Avocado seed floater - mason jar compatible
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An avocado seed floater that fits in jars with an internal dimension smaller than 68mm (.. approx 2.67ish inches)
- Rating
- 4 / 5
- Likes
- 9
- Downloads
- 30
- Makes
- 1
- Views
- 190
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hey!
I was using this model made by Mikolas Zuza, but it sadly did not fit any of my jars - it was just a little too big. Instead of scaling it down I used it as a designing excercise to make essentially the same model, except that it is smaller, and is designed for 0.6mm nozzles.
How to make the model “watertight”
- force the slicer to use bigger line width (eg. stock is 0.62 → use 0.67)
- use higher flow ratio (eg. stock is 0.98-1.0 → use 1.1)
- bump the temp up, for PLA I used 240°, instead of 205-215° which I normally use
- slow the print down, I used 50-75mm/s
- experiment with filaments, petg should be easier than pla for this, but I used PLA and made it work