Fish Fillet Board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fish Fillet Board replica of my grandfathers original made in the 1970s.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Fish Fillet Board is a decorative replica my grandfathers 1970s original. Board is printed using beige and red petg with 15% infill, no support or brim, with 2 filament changes added on edge tangent points. Clamp is printed in place with 25% (or more for strength) infill, supports, brim and one filament change at 65% of layer height. Gap between parts is .012 inches when printed at 50%. Print scale at 50% (inches) or 1270% (metric). Overall length is 11.75"/298.45mm at 50% scale. Clamp provided with and without joint and fastener edge detail.
Print fish at same scale. Shown printed using transparent gray and translucent blue/green dual color.
The salmon fish half is a remake of the Salmon fish by Peter Farell.