Fish Fillet Board
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fish Fillet Board replica of my grandfathers original made in the 1970s.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 6
- Makes
- 0
- Views
- 71
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Fish Fillet Board is a decorative replica my grandfathers 1970s original. Board is printed using beige and red petg with 15% infill, no support or brim, with 2 filament changes added on edge tangent points. Clamp is printed in place with 25% (or more for strength) infill, supports, brim and one filament change at 65% of layer height. Gap between parts is .012 inches when printed at 50%. Print scale at 50% (inches) or 1270% (metric). Overall length is 11.75"/298.45mm at 50% scale. Clamp provided with and without joint and fastener edge detail.
Print fish at same scale. Shown printed using transparent gray and translucent blue/green dual color.
The salmon fish half is a remake of the Salmon fish by Peter Farell.