1mm Magnet Wafers/Spacers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnet wafers to fix dimensions. Printable with low filament to use up the end of the spool. Print by OBJECT.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
These wafers allow for 1mm compensation for disk magnets. If all you have are 8x2mm, but a design calls for 8x3, drop one of these in first before press-fitting the magnet. I usually run this plate when I have a tiny bit of a spool left just to run out the filament and add these to the collection.
I print mostly ASA which shrinks very slightly. If printing in PLA, I scale X and Y to 99.8% to make sure these drop in.
Just under 2 grams of filament. Perfect amount for when the runout sensor on the Centauri Carbon is about to be hit.
Make sure to print by object if you plan to just run out the filament during the print.