Magnetic AND Clamping 270° Hinges

Clamps the panels instead of having to drill holes or use VHB tape.
Can be taken off and put back on with one hand quite quickly, but uses one of the magnets as a sort of centering pin to make sure the doors dont just fall off.

The “+” versions use extra magnets in the mounted part, so 6 total magnets for the default and 3 total for the centering hinge.

Default and “+” versions use the same “Top”-part, and all versions use the same “Bottom”-part

I suggest using one centering hinge at the top, and two or three default ones evenly spaced under it.

All parts print without any supports, some are still oriented wrong (i'll be fixing that eventually)

Remember that you need to mirror BOTH centering pieces for the other side, the default hinges dont need the mirroring.

Foam tape and your panels together need to be 6mm thick, maximum 6.2 or the doors wont close properly, this works with the stock Voron Panels, but also with slightly bigger ones.
I recommend Wafer head screws, as you can see in the Pictures they look much better.

BOM (6 Hinges):
-M3x10 WHS (or SHCS/BHCS)      12 Pcs
-M3 Hex-Nut                                       12 Pcs
-M3x8 SHCS (or BHCS)                     6 Pcs
-M3 Roll-in or T-nuts                           6 Pcs
-6x3mm Magnets (6x2.7 works)      30 Pcs
-Foam tape (6mm minus panel thickness)
-Superglue

BOM (6 Hinges, extra Magnets):
-M3x10 WHS (or SHCS/BHCS)      12 Pcs
-M3 Hex-Nut                                       12 Pcs
-M3x8 SHCS (or BHCS)                     6 Pcs
-M3 Roll-in or T-nuts                           6 Pcs
-6x3mm Magnets (6x2.7 works)      20 Pcs
-Foam tape (6mm minus panel thickness)
-Superglue

BOM (8 Hinges):
-M3x10 WHS (or SHCS/BHCS)      16 Pcs
-M3 Hex-Nut                                       16 Pcs
-M3x8 SHCS (or BHCS)                     8 Pcs
-M3 Roll-in or T-nuts                           8 Pcs
-6x3mm Magnets (6x2.7 works)      42 Pcs
-Foam tape (6mm minus panel thickness)
-Superglue

BOM (6 Hinges, extra Magnets):
-M3x10 WHS (or SHCS/BHCS)      16 Pcs
-M3 Hex-Nut                                       16 Pcs
-M3x8 SHCS (or BHCS)                     8 Pcs
-M3 Roll-in or T-nuts                           8 Pcs
-6x3mm Magnets (6x2.7 works)      32 Pcs
-Foam tape (6mm minus panel thickness)
-Superglue