Dart Zone/Adventure Force Matrixfire Magazine Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This attachment clips on to your matrixfire to allow it to accept Nerf and similar magazines.
- Ocena
- 4,8 / 5
- Polubienia
- 96
- Pobrania
- 484
- Wydruki
- 8
- Wyświetlenia
- 3988
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
Update 27Dec2022-All files have been updated; more Detail for both spring and elastic versions. Spring version clearances updated. Both require one 7/8" 4-40 screw or similar. Spring release requires one 3/8" 4-40 screw.
Update 16May2022-Added elastic version with more clearance, extended mag release, and detailed filler piece. Step files included
Update 25Mar2022-Removed lip which could occasionally catch AF waffles
Replaces the matrixfire hopper to allow it to feed magazines. Rewire the blaster to a 2s or 3s lipo for best results. If running on 3s, I recommend adding a PWM to control the speed of the feed wheel, since on full 3s it can burn grooves in darts.
Supports: Yes, but only necessary for the “nub” hanging over the right side. The elastic version uses sacrificial bridging to create the hole which can be cleared away after the print is complete.
Hardware:
Spring version: 1x ¾" - 1 ½" screw and one appropriately sized extension spring (Captain slug style and sizing). I also used a variety pack from harbor freight.
Elastic version: 1x ¾" - 1 ½" 4-40 screw and about 4" of 3/32" elastic. Tie a knot in the end and feed it through the mag release end. Pull out through the top of the adapter, pull tight, and tie a second knot as close to the receiver as possible. Trim away excess