HSP Racing 1/10 Scale Steering Set A (part #20706) - Top only
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Temporary fix for the HSP Racing 1/10 Scale Steering Set A (part #20706) servo saver top part.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a 3D-printed replacement / temporary fix for the HSP Racing 1/10 Scale Steering Set A (spare part number 20706) – steering servo saver top part.
The original plastic component is prone to failure when paired with a strong servo that is not correctly adjusted (e.g., excessive throw causing stress and snapping). To get you back on the track quickly, I modelled this spare part as a functional substitute.
⚙ Key details:
- Fits: HSP Brontosaurus Racing 1/10 scale RC models using Steering Set A (part #20706)
- Purpose: Replacement for the servo saver top part that often breaks under load
- Material tested: PETG (recommended for durability and slight flex under stress)
Print settings:
- Layer height: 0.12 mm
- Supports: Required
- Infill: 100%
- Orientation: Print flat for best strength
Notes: While this print works well as a temporary replacement, it’s not intended to be stronger than the original part. Over-tightening your servo or misadjusting endpoints can still cause breakage.
This part was successfully tested on my own RC car with PETG, but depending on your setup, ABS or Nylon may provide longer-term durability.