Baffles for Disco on a XXL Stick - Lab4450 Version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As no other baffles seem to fit the Disco on a XXL Stick PCBs from Lab4450, here's a version that does.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 20
- Wydruki
- 1
- Wyświetlenia
- 258
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I'm not sure what's so different about the Disco on a XXL Stick PCB from Lab4450, but none of the other baffles available on here seem to fit - so i created my own version. They're a bit oversized because i first thought i'll create a whole mounting solution (which may still come later) that completely wraps the PCB, but for now it's just the baffles.
These baffles are supposed to be mounted with any of the readily available LED bar mounts for 2020 extrusion that use a M3 bolt and tilt the PCB at at 45° angle - or any other angle you prefer.
As the bolt holes are slightly offset, there are a “Left” and a “Right” version that will put the “Data In” (DIN) connector to the back of the printer. Feel free to swap them around if your cables are coming from the front. Either way, there's a small arrow on the backside that points in the direction of the data signal flow.
You could even mount them “the wrong way around” and would only notice it by looking closely at the spacing between the PCB and the frame at the sides. Yes, the offset is that minimal… but still.