IKEA SKÅDIS Clamp for HueForge Filament Paintings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Turn your SKÅDIS into an art gallery! Clamp mount for HueForge filament paintings.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So… I got myself a big IKEA SKÅDIS pegboard – actually two of the 56 × 56 cm panels. My master plan was to fill it up with all the useful tools and gadgets for 3D printing. But you know how it goes: lots of space, not enough stuff.
At some point I thought: “Why should my SKÅDIS look like a hardware store, when it could look like an art gallery?”
That’s where these little clamps come in. They snap onto the SKÅDIS and hold your HueForge filament paintings nice and steady at the bottom edge. Usually, two clamps per painting do the trick.
So if your SKÅDIS is begging for more style and less bare plastic holes, this is your upgrade. Turn that board into the Louvre of 3D printing – one filament layer at a time.
Printing information
All STL files are correctly aligned.
Layer height: 0.2 mm
Perimeter: 2
Infill: 20 %
Support: no
I am looking forward to your Makes! :-)
If you like this design, feel free to check out my others here.