Bezel for Framework 16
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bezel model based on Framework model and custom measurements made to fit on the Framework 16
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 464
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Updated model now available:
This model is meant to be printed with PLA and fit into the bezel for the Framework 16. It is still in development and at some point, should have variations for TPU also.
Note for Slider Version:
The assembly for the sliders should use a piece of zinc flashing, like the magnet areas on the bezel. the “Holding nub” should attach to the bottom of the cam or mic sliders (glue) and be installed in the bezel then have the Slider covers on top.
You will need two of these assemblies
If you found value in this model I would appreciate if you would consider buying me a coffee @: buymeacoffee.com/MapouT