Logitech Litra Beam Surface Mount

If you're tight on space but want to look fabulous in your Zooms, this gets your key light off your desk.

Note: There's three versions, one with square edges (pictured) and one with curved edges (see model names), and a replacement Left that has Micron pen stash holes if that's your jam.

I bought a Litra Beam but with limited space on my desk it was always competing for space so I ended up not using it. It also has wires coming out of one side, switches on the other and light out of both sides so I couldn't just set it on top of a shelf. This puts the litra just below the shelf and has space for the wires to come out the back.

This mount allows for both front and back lights to work unobstructed, hides the wires at the top (you will need a right angle USB-C), and allows easy access to the buttons on the bottom.

* Print a Left, Right and Center. 
* Attache one side to the underside of the shelf with a screw
* Hold the light up with the other side and mark the location
* Remove the light and attach the other side
* With cables attached, slide the light in from the front, it should stop on the small lips on the back of the left and right mounts
* Push the center in, it is easiest to get the left side in and then push the right side in, if your mounting marks were correct and your printer in decent shape, it should fit just right.