Centauri Carbon riser remix - no sliding top, no gaps for heat retention
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Centauri carbon riser remix with multiple new options for PTFE routing, heat retention, and non-sliding covers
- Ocena
- 3 / 5
- Polubienia
- 11
- Pobrania
- 122
- Wydruki
- 1
- Wyświetlenia
- 927
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of the original to address a few issues I had:
- Cover was sliding off the back on some long prints due to vibrations
- Extruded the lip to match the front two pieces to fully retain the glass top
- PTFE guide was allowing too much airflow for ASA/PC prints
- Removed the PTFE cover (back left option one
- When used, PTFE guide was cutting into tubing
- Added an option with the PTFE guide with extra chamfering as well as retaining lip
In the supplied 3MF, the plates are as follows:
Plates 1 and 2 - original four parts
Plate 3 - Remixed back right piece with rear lip and removed wire passthrough
Plate 4 - Remixed back left piece, two options. One option has the improved PTFE passthrough, the other does not. Both have the rear lip.
Plate 5 - Dowels
Fully compatible with original model - print just the back left and/or back right piece and swap in - the front has not been modified