Centauri Carbon riser remix - no sliding top, no gaps for heat retention
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Centauri carbon riser remix with multiple new options for PTFE routing, heat retention, and non-sliding covers
- Rating
- 3 / 5
- Likes
- 11
- Downloads
- 122
- Makes
- 1
- Views
- 927
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is a remix of the original to address a few issues I had:
- Cover was sliding off the back on some long prints due to vibrations
- Extruded the lip to match the front two pieces to fully retain the glass top
- PTFE guide was allowing too much airflow for ASA/PC prints
- Removed the PTFE cover (back left option one
- When used, PTFE guide was cutting into tubing
- Added an option with the PTFE guide with extra chamfering as well as retaining lip
In the supplied 3MF, the plates are as follows:
Plates 1 and 2 - original four parts
Plate 3 - Remixed back right piece with rear lip and removed wire passthrough
Plate 4 - Remixed back left piece, two options. One option has the improved PTFE passthrough, the other does not. Both have the rear lip.
Plate 5 - Dowels
Fully compatible with original model - print just the back left and/or back right piece and swap in - the front has not been modified