1 / 3
Monitor Mount Pole Topper
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
add some 1/4-20 mounting to the top of your pole
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Got a pole you want to stick something on top of?
I did, and it was a light. instead of clamping, which seemed ugly, I stuck something in the hole. first iteration started to wobble after time so I slashed it at 45 degrees and now it suspends.
Requirements:
- M4 screw (30mm works best. 25mm should be ok)
- M4 washer
- M4 threaded insert
- ¼"-20 threaded insert (mine are ¾" length but shorter should be okay)
Construction:
- add M4 heat set insert from flat side of smaller part
- insert M4 screw through flat side of larger part
- screw pieces together, but not tight
- add ¼"-20 insert
you are effectively locking in place the M4 screw - slide into the pole hole
- tighten M4 screw
- add accessories
You will find the ¼" hole is recessed, adjust z of object to achieve desired depth.
I'm really not good at modelling so this is a slicer-constructed model