1 / 10
Ikea Lennart Drawer Clip - Stop Drawers Falling Out, AKA the Lennart Hammer | Simple clip in — zdjęcie 1
1 / 10

Ikea Lennart Drawer Clip - Stop Drawers Falling Out, AKA the Lennart Hammer | Simple clip in

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is what I call the "Lennart" Hammer, a clip for holding Lennart drawers in place without falling out of the cubby.

Ocena
5 / 5
Polubienia
9
Pobrania
84
Wydruki
0
Wyświetlenia
434
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution

This is what I call the "Lennart" Hammer.  I tried a few other clips and although interesting, they didn't work the way I wanted a clip to work.  So I sat down and created these bad boys from scratch.

This part is "universal", so you'll need to add 6 of them (2 per drawer).  Depending on your slicer, you may need to rotate the STL.  Look at the photo and make sure you match the orientation.

What is "The Hammer"?
- Universal clip to stop lennart drawers from falling out
- Uses a heavier "hammer" base to stop the sliding out, but also has some pretty awesome durability
- Simply slide it into the rear "gap" in your mesh from creating the drawers
- The clips do "bite" once clipped in.  Make sure pay attention to this if you need to remove them later

Yes, you can make and sell these.  Blend file attached for easier modification.

The clips are super easy to clip and clip out, easily adjustable, and have a bit of a “bite” (thanks to gravity) that lets them stay where you place them.  I found being about 2 / 3 of the way feels right, but it is very easy to adjust the depth of the drawer and to move these clips around.

Anyway, loving my drawers - cheap affordable metal drawers are cool.  Thank you mister ikea.

 

Version 2.0 - 2025 - 09 - 14

  • More variety of width and depth

Version 1.0 - 2025 - 08 - 30

  • Initial release

Tagi