Victorinox (Swisstech) Keychain Knife Toothpick
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement toothpicks for a very small, keychain sized Victorinox/Swisstech brand pocketknife.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update:
Added a v2 design that improves a few small things (below). I left the original file as well in case that worked well for anyone.
- Widened the tab on the side of the toothpick to improve the fit/capture in the knife. It'll feel a little tight the first few times you insert/remove it, but after a handful of uses it'll feel closer to the original part.
- Extended the “cap” at the top of the toothpick to make it a little easier to pull in and out with your fingernail.
- Blunted the tip a little more so that the plastic didn't immediately deform while in use.
- Lengthened the toothpick slightly to account for the rounded tip and more closely match the original part.
Original description:
There's a few others of these, but they didn't fit my little keychain knife. Far cheaper than replacements online ($6/6). I printed in PETG, probably other materials are fine, too. I used .08mm layers, which if you print enough to not trigger the minimum layer time should take about 1 min/toothpick. I also used Arachne wall generator to try and get a fine point.