1 / 1
Victorinox (Swisstech) Keychain Knife Toothpick — image 1

Victorinox (Swisstech) Keychain Knife Toothpick

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement toothpicks for a very small, keychain sized Victorinox/Swisstech brand pocketknife.

Rating
0 / 5
Likes
7
Downloads
42
Makes
0
Views
212
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Update:
Added a v2 design that improves a few small things (below). I left the original file as well in case that worked well for anyone. 

  1. Widened the tab on the side of the toothpick to improve the fit/capture in the knife. It'll feel a little tight the first few times you insert/remove it, but after a handful of uses it'll feel closer to the original part.
  2. Extended the “cap” at the top of the toothpick to make it a little easier to pull in and out with your fingernail.
  3. Blunted the tip a little more so that the plastic didn't immediately deform while in use.
  4. Lengthened the toothpick slightly to account for the rounded tip and more closely match the original part.

Original description:
There's a few others of these, but they didn't fit my little keychain knife. Far cheaper than replacements online ($6/6). I printed in PETG, probably other materials are fine, too. I used .08mm layers, which if you print enough to not trigger the minimum layer time should take about 1 min/toothpick. I also used Arachne wall generator to try and get a fine point.

Tags