BreachHueforge | Twenty One Pilots
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Breach Album Hueforge | Twenty One Pilots |-/
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 162
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Breach Album Hueforge | Twenty One Pilots
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x198.2mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.8mm and the Actual Depth is 2.9mm
Filaments Used:
PLA eSUN Black Transmission Distance: 0.8
PLA eSUN Fire Engine Red Transmission Distance: 5.4
PLA BambuLab Basic Red Transmission Distance: 4
PLA eSUN Red Transmission Distance: 4.8
PLA eSUN Beige Transmission Distance: 3.5
PLA eSUN Cold White Transmission Distance: 5
This print uses 6 unique filaments
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Fire Engine Red
At layer #13 (1.12mm) swap to Red (Bambu)
At layer #18 (1.52mm) swap to Red (eSUN)
At layer #24 (2mm) swap to Beige
At layer #29 (2.4mm) swap to Cold White for the rest.
… or use the .3mf file ;)
If you're using an AMS with 4 slots replace the following filaments with the new colors as you go:
- swap Black with Beige
- swap Fire Engine Red with Cold White