EGO Battery Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
UPDATE: Sept. 18, 2017. Added original parasolid files on request. Good luck!Mounted this above the EGO battery…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 275
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
UPDATE: Sept 01, 2025. Someone made a remake of this, which is linked to my Thingiverse account. The next time I add more batteries, I will be printing the remake, it appears to have stronger support for heavier batteries.
UPDATE: Sept. 18, 2017. Added original parasolid files on request. Good luck!
Mounted this above the EGO battery charger to hang the extra battery on. Designed to fit all current EGO battery sizes. Tested with 2.0 Ah, 2.5 Ah, and 4.0 Ah.
I realized after printing that a smaller version should work just as well. I put holes for screw and washer. There is a large clearance for bolts or screws.
Goes with these things: Trimmer http://www.amazon.com/exec/obidos/ASIN/B00TZLUEFG/donscollecti Lawn Mower http://www.amazon.com/exec/obidos/ASIN/B00NOGZCI2/donscollecti Blower http://www.amazon.com/exec/obidos/ASIN/B00ZNZUZT8/donscollecti Chain Saw http://www.amazon.com/exec/obidos/ASIN/B0102PWY38/donscollecti
Print Settings
Printer:
Creator
Rafts:
No
Supports:
No
Resolution:
.3
Infill:
20%
Notes:
Interesting note. I hollowed out the middle of this with a pretty big hole, but Simplify 3D reported it would take 45 minutes longer and use 1 meter more filament. So I went back to the solid version. All I could figure is the 2 shell wall of the hollow cost more time and filament than a solid 20% fill.
Category: Organization