Rubber Sleeve for VELUX Roller Shutter Handle Rod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rubber Sleeve for VELUX Roller Shutter Handle Rod
- Ocena
- 4 / 5
- Polubienia
- 13
- Pobrania
- 86
- Wydruki
- 1
- Wyświetlenia
- 485
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
The original rubber sleeves of the handle rods for the VELUX roller shutter become brittle over time and breaks out.
The part provided here can replace these sleeves 1:1.
Print Settings
Printer:
FIashForge Dreamer
Rafts:
No
Supports:
No
Resolution:
0.20mm
Infill:
100%
Filament:
TPE white
Notes:
You must use as most as possible flexible Filament (TPU, TPA or TPE).
I used TPE on 235°C, no fan and with a print speed of only 30mm/s. Put the part with the side with the thin wall upwards. It is designed to be able to print the inner overhangs without support in this orientation. So don't change the original orientation from file.
Post-Printing
Cut off the old sleeve and press the new sleeve in the correct orientation with gentle pressure in position. Depending of the flexibility of your material you may be need a bit more pressure to slip the sleeve over the rod.
Category: Replacement Parts