Expanded back for the Lilygo T-Lora Pager
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified back to accommodate larger battery size. Compatible with T-Lora Pager models 433/868/915/920MHz.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 198
- Wydruki
- 0
- Wyświetlenia
- 936
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Modified the back of the T-Lora Pager to allow for a larger battery. The extra unused antenna “wing” was also removed.
*Note* This is a fairly involved teardown and rebuild of the T-Lora Pager and you do so at your own risk.
Refer to the PDF walkthrough document for the breakdown and rebuild procedure.
What you will need:
- T-Lora Pager model 433/868/915/920MHz
- Small Phillips screw driver
- Soldering iron
- Guitar picks or plastic “spudger”
- MakerFocus 3000mAh battery with a Micro JST 1.25 connector
- 3950 NTC 10K thermistor
- Panel mount switch
- 20 gauge wire or similar
- M2 screws for mounting the switch
- Heat shrink tube
- T-Lora Pager back (3D printed in PET-G preferred)
Printing:
I printed this with the back to the bed and used supports under the antenna cutout.
If you would like to support me, you can do so here: https://buymeacoffee.com/cod3doomy